PEX Clamp Generator.

Configure your clamp, inspect it in 3D and download STL files for printing.

Your clamp

Number of pipes

◯ Single ◯◯ Double

Threaded rod

M8 M10

Outer pipe diametermm

10–80 mm. Include insulation in the diameter if fitted.

Clear gap between pipesmm

Between the outer pipe surfaces, 0–100 mm.

Lower reinforcement

Fit and construction

Diameter allowancemm

Pipe bore = diameter + allowance. Wall and ties 5 mm, ring and mount axial width 33 mm, split gap 0.6 mm. Two M5 bolts. Side pocket for DIN 934 nuts includes 0.3 mm allowance: M8 13.3 × 6.8 mm; M10 17.3 × 8.3 mm. Rod bore: M8 Ø8.8 mm; M10 Ø10.8 mm. Full-width lower reinforcement is enabled by default.

Two separate parts with the flat rear faces on the bed. Units: mm.

Loading generator…

2 × Ø40 / M10Two-part · ceiling mount

Upper part + mountLower part

Drag to rotate · scroll or pinch to zoom Show pipes and rod

Overall dimensions: —
Bore / rod: —
Nut pocket: —

02 / ASSEMBLY

Two parts. One assembly.

Insert an M8 or M10 nut from the side of the upper mount and screw the threaded rod in from above. Close the clamp around the pipes with two M5 bolts and two M5 nuts. Bolts, nuts, rod and preview pipes are not included in the STL.

03 / BEFORE PRINTING

Check the fit first.

The generator checks geometry; load capacity has not been tested. Test-print and check the fit of the nut, rod and pipe. Choose material and settings for the temperature and load. The flat rear faces lie on the print bed. Check supports for horizontal bolt and threaded-rod holes in your slicer. Verify the complete assembly’s load capacity before permanent ceiling installation.